Case Carton Sealer/ Box Taper

1. The nail clamping action is too slow or the nail clamping stroke is insufficient:
The bolt is loose, and the front buckle or the inner plate of the trigger is worn. At this time, the bolt can be tightened, paying attention to the correct position of the front buckle shaft.
You can also replace the front buckle or the trigger inner film. After completing the above actions, test its function. If the stroke is too short, fine-tune the front buckle shaft upwards, and fine-tune the front buckle shaft downwards if the movement is slow;
2. Air leakage at the piston rod: The bottom ring of the main body is damaged. The ring should be replaced at this time.
3. Air leakage at the exhaust port: the switch valve ring or switch seat ring is damaged or the piston ring is damaged. Replace the ring.
4. Air leakage at the trigger: the switch valve ring or switch seat ring is damaged. Replace the ring.
5. The transmission ring is loose and cannot be positioned: the plastic steel bar and the transmission spring are inelastic. Remove the trigger assembly and reinstall the spring pin or replace the plastic steel bar and drive spring.

1. Install and wind the tape, adjust the tape to the middle position.
2. Adjust the air pressure.
3. Check if there is water in the oil-water separator, drain the water; check if the amount of oil is sufficient, and if it is insufficient, add it.
4. Adjust the position of the side pressure roller.
5. Adjust the swing rod to the proper position.
6. Press the switch ON button to turn on the power and make the machine run.
7. Push the carton in from the input end of the machine (the sealing cover on the top of the box must be erected), and release it when it is driven by the conveyor belt. When the carton touches the rear flap control switch, the cylinder piston extends and pushes to fold back The cover is raised. When the carton completely passes through the rear flap control switch, the rear flap control switch is reset. At this time, the cylinder piston shrinks, and the rear flap falls, pressing the rear cover of the carton, and both sides of the carton are under the action of the swing lever. After completing the side cover folding action, the purpose of folding and sealing the box can be completed. Then the tape applicator completes the work of applying the tape.
8. The order of folding cover is: front cover, back cover, left and right side cover.
9. Press the OFF button of the switch, disconnect the power supply, and stop the machine.

When you choose a carton sealer machine,you may confused how to choose it, here we introduce some tips for it.

1. First, the customer must determine the packaging method of the product; product size, product weight; whether the product is regular or not; the output that needs to be packaged every day. How many people are currently packing to complete the output.
2. According to the product packaging parameters provided by the customer, help the customer to determine the model of the packer. If the product is larger than 20KG, it is recommended to use the low model carton sealer machine, and the carton sealer machine for packaging carton products and regular products can be selected. For special products, we can customize a packager equipment suitable for customers according to the actual situation.
3. Secondly, help customers determine the width and thickness of the packing belt and the material of the packing belt. (Whether to choose the cost-saving and environmentally friendly material packing belt) According to the selected carton sealer machine model, product weight and customer requirements, choose the specification and model of the packing belt.